INVERTER BASED AIR PLASMA CUTTING MACHINE AIRCUT - 200-300 IW

AIRCUT-200 IW, AIRCUT-300 IW machine are inverter based air plasma cutting machine. They are widely used for cutting ferrous as well as non ferrous metals using inexpensive air as the cutting media.

FEATURES

• Advanced ‘Soft switching’ technology, hence more reliability
• High Frequency Arc Striking
• High power factor & efficiency
• Good cutting quality
• Continuous adjustment of current possible
• Air Failure protection switch with indication
• Water failure Protection with indication
• Protection against thermal over load
• Two levels of air flow system to ensure smooth pilot arc
• Up sloping of current to increase the consumable life
• Higher on-load voltage and hence higher speed of cutting
• Bigger output inductor for extra smooth DC output which results in better cut finish

Scope of Supply

Power source along with water cooling system 5 mtr hand held water cooling torch,Air filter,Earthing Cable,3 sets of Electrode,Nozzle

Technical Specification

Model	Cutting Thickness	Input Power (KVA)	Current Range	No Load voltage (DC)
AIRCUT-200 IW	Clean Cut in MS,SS-70mm Rough Cut in MS,SS-75mm Recommended Thickness on trolley=55mm	39	60 ~ 200	380
AIRCUT-300 IW	Clean Cut : 100mm in MS,SS Rough Cut : 105mm in MS,SS	70	80 ~ 300	380
Recommended Thickness on trolley=80mm
Input Supply 380 ~ 440 V 3 - phase 50 Hz Supply
Efficiency – 85%
Power Factor – 0.85
Duty Cycle - 100%
Air Pressure Required in KG/CM2 - 5 ~ 6
Type of Plasma Cutting Torch-Water Cooled
Air Flow Required(CFM)-5~6